You are here: Home > CLI Commands > Just_CLI_Topics > show wms monitor-summary

show wms monitor-summary

show wms monitor-summary


This command displays the number of different AP and client types monitored over the last 5 minutes, 1 hour, and since the managed device was last reset.


No parameters.

Usage Guidelines

The WLANWireless Local Area Network. WLAN is a 802.11 standards-based LAN that the users access through a wireless connection. management system (WMS) monitors wireless traffic to detect any new AP or wireless client stations that attempt to connect to the network. When an AP or wireless client is detected, it is classified and its classification is used to determine the security policies which should be enforced on the AP or client. Use the show wms monitor-summary command to view a quick summary of each classified AP and client type currently on the network.

If AP learning is enabled (with the wms general command), non-Aruba APs connected on the same wired network as Aruba APs are classified as valid APs. If AP learning is disabled, a non-Aruba AP is classified as an unsecure or suspect-unsecure AP.


The following example displays a summary of monitored APs and clients on a managed device:

(host) [mynode] #show wms monitor-summary


WMS Monitor Summary


Last 5 Min Last Hour All

- ---------- --------- ---

Valid APs 1 1 1

Interfering APs 57 57 60

Rogue APs 3 3 3

Manually Contained APs 0 0 0

Unclassified APs 0 0 0

Neighbor APs 0 0 0

Suspected Rogue APs 138 138 139

Valid Clients 0 0 0

Interfering Clients 1 1 1

Manually Contained Clients 0 0 0

Related Commands



wms ap

This command allows you to classify an AP into one of several categories.

wms client

This command allows you to classify a wireless client into one of several categories.

Command History




Command Introduced.

Command Information



Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.