You are here: Home > CLI Commands > Just_CLI_Topics > show wms rules

show wms rules

show wms rules

config

state

summary

Description

This command displays the internal state and matching information of rules created using the ids ap-classification-rule command.

Syntax

Parameter

Description

config

Displays the following information for each AP classification rule:

name

ids

match-ssidService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network.

min-snr

max-snr

min-prcnt

max-prcnt

ssidsService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network.

enabled

classify

conf-incr

flags

match-cnt

state

Displays the following information for each AP classification rule:

SSIDService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network. Match Table

SSIDService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network. Exclude Table

SNRSignal-to-Noise Ratio. SNR is used for comparing the level of a desired signal with the level of background noise. Table

Probe Count Table

summary

Displays a summary of AP classification rules.

Usage Guidelines

Issue this command to view existing AP classification rules. AP classification rule configuration can only be performed on a Mobility Master. If AMPAirWave Management Platform. AMP is a network management system for configuring, monitoring, and upgrading wired and wireless devices on your network. is enabled via the mobility-manager command, then processing of the AP classification rules is disabled on Mobility Master. A rule is identified by its ASCIIAmerican Standard Code for Information Interchange. An ASCII code is a numerical representation of a character or an action. character string name (32 characters maximum). The AP classification rules have one of the following specifications:

SSIDService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network. of the AP

SNRSignal-to-Noise Ratio. SNR is used for comparing the level of a desired signal with the level of background noise. of the AP

Discovered-AP-Count or the number of APs that can see the AP

Example

The output in the example below shows that although two rules have been defined, neither have been enabled using the ids ap-rule-matching rule-name <name> command.

(host) [mynode] #show wms rules summary

 

AP Classification Rules Summary

-------------------------------

Parameter Value

--------- -----

Num Rules 2

Num Active-Rules 0

Num SSID-to-match 0

Num SSID-to-exclude 0

Num SNR-bounds 0

Num Probe-Count-bounds 0

Related Commands

Command

Description

wms client

This command configures the IDSIntrusion Detection System. IDS monitors a network or systems for malicious activity or policy violations and reports its findings to the management system deployed in the network. AP classification rule profile.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/