ArubaOS Help Center
You are here: Home > Authentication Servers > Configuring a Windows Server

Configuring a Windows Server

The following table defines parameters for a Windows server used for stateful NTLM authentication.

Table 1: Windows Server Configuration Parameters




IP address of the server.

Default: N/A


Enables or disables the server.

Default: enabled

Windows Domain

Name of the Windows Domain assigned to the server.

The following procedure describes how to configure a Windows server:

1. In the Mobility Master node hierarchy, navigate to the Configuration > Authentication > Auth Servers tab.

2. To configure a Windows server, click + under All Servers. Enter the Name and IP address / hostname of the server. Set the Type to Windows and click Submit.

3. Select the server created to configure server parameters. Enter the parameters as described in Table 1.

4. Select the Mode check box to activate the authentication server.

5. Click Submit.

6. Click Pending Changes.

7. In the Pending Changes window, select the check box and click Deploy changes.


The configuration does not take effect until you perform this step.

The following CLICommand-Line Interface. A console interface with a command line shell that allows users to execute text input as commands and convert these commands to appropriate functions. commands configure a Windows server:

(host) [mynode] (config) #aaa authentication-server windows <windows-server-name>

host <ipaddr>