Configuring Upgrade Profile of Mobility Master

The following procedure describes how to configure an upgrade profile for the Mobility Master.

1. In the Mobility Master node hierarchy, navigate to Maintenance > Software Management > Upgrade.

2. Configure the parameters described in the following table:

Table 1: Upgrade Image Parameters for Mobility Master

Parameter

Description

Upgrade using

Select the protocol used to download the image file.

FTP File Transfer Protocol. A standard network protocol used for transferring files between a client and server on a computer network.

Local File

SCP Secure Copy Protocol. SCP is a network protocol that supports file transfers between hosts on a network.

TFTP Trivial File Transfer Protocol. The TFTP is a software utility for transferring files from or to a remote host.

USB Universal Serial Bus. USB is a connection standard that offers a common interface for communication between the external devices and a computer. USB is the most common port used in the client devices.

Server IP address

Specify the IPv4 address of the image server.

NOTE: Specify this parameter if SCP, FTP, or TFTP is used as the protocol to download the image file.

Image file name

Specify the image file name.

NOTE: Use the Browse button to navigate to the image file if Local File is used as the protocol to download the image file.

Username

Specify the username to log in to the image server.

NOTE: Specify this parameter if FTP or SCP is used as the protocol to download the image file.

Password

Specify the password to log in to the image server.

NOTE: Specify this parameter if FTP or SCP is used as the protocol to download the image file.

Partition to upgrade

Select the partition to upgrade.

Reboot controller after upgrade

Enable the toggle switch to reboot the Mobility Master after upgrade.

Save current configuration

Select the check box if the existing configuration on the Mobility Master should be saved before rebooting.

NOTE: The existing configuration on the Mobility Master is saved before it is rebooted only if the Reboot controller after upgrade toggle switch is enabled.

3. Click Upgrade.