You are here: Ethernet Configuration > Configuring Wired Bridging on Ethernet 0
Previous TopicNext Topic

Configuring Wired Bridging on Ethernet 0

Instant supports wired bridging on the Ethernet 0 port of an IAP.

 

Enabling wired bridging on this port of an IAP makes the port available as a downlink wired bridge and allows client access through the port. You can also use the port to connect a wired device when a 3G uplink is used.

You can configure support for wired bridging on the Ethernet 0 port of an IAP using Instant UI or CLI.

In the Instant UI

To configure Ethernet bridging:

1. In the Access Points tab, click the IAP to modify. The edit link is displayed.
2. Click the edit link. The edit window for modifying IAP details is displayed.
3. Click the Uplink tab.
4. Select Enable from the Eth0 Bridging drop-down menu.
5. Click OK.
6. Reboot the IAP.

In the CLI

To configure Ethernet bridging:

Instant Access Point# enet0-bridging