You are here: CLI_commands > show ip route
Previous TopicNext Topic

show ip route

show ip route


This command displays the IAP routing table.

Usage Guidelines

Use this command to view the IP routes configured for an IAP.


The following output shows the ip address of routers and the VLANs to which they are connected.

Kernel IP routing table

Destination Gateway Genmask Flags MSS Window irtt Iface UH 0 0 0 tun0 U 0 0 0 br0 U 0 0 0 br0 U 0 0 0 br0 UG 0 0 0 br0

The output of this command provides the following information:




Displays the destination IP address for the IP routes.


Displays the gateway IP address for the IP routes.


Displays the subnet mask details for the IP routes.


Indicates if the route is up (U), targeted to the host (UH), or if it uses Gateway (UG).
MSS Indicates the default maximum segment size for TCP connections over this route.
Window Indicates the default window size for TCP connections over this route.
irrt Indicates the initial RTT (Round Trip Time). The kernel uses this to determine the best TCP protocol parameters instead of relying on slow responses.
Iface Indicates the Interface to which packets are routed.

Command History



Aruba Instant

This command is introduced.

Command Information

IAP Platform

Command Mode

All platforms

Privileged EXEC mode