Configuring Wired Bridging on Ethernet 0 for Mesh Point

Instant supports wired bridging on the EthernetEthernet is a network protocol for data transmission over LAN. 0 port of an Instant AP. If Instant AP is configured to function as a mesh point, you can configure wired bridging.

 

Enabling wired bridging on this port of an Instant AP makes the port available as a downlink wired bridge and allows client access through the port.

 

When using 3GThird Generation of Wireless Mobile Telecommunications Technology. See W-CDMA. uplink, the wired port will be used as downlink.

You can configure support for wired bridging on the EthernetEthernet is a network protocol for data transmission over LAN. 0 port of an Instant AP by using the WebUI or the CLICommand-Line Interface. A console interface with a command line shell that allows users to execute text input as commands and convert these commands to appropriate functions..

In the Old WebUI

To configure EthernetEthernet is a network protocol for data transmission over LAN. bridging:

1. On the Access Points tab, select the Instant AP to modify.

2. Click the edit link.

3. Click the Uplink tab.

4. Select Enable from the Eth0 Bridging drop-down list.

5. Click OK.

6. Reboot the Instant AP.

In the New WebUI

To configure EthernetEthernet is a network protocol for data transmission over LAN. bridging:

1. Go to Configuration > Access Points and select the Instant AP to modify and click Edit.

2. Expand Uplink.

3. Toggle the Eth0 bridging switch to enable.

4. Click Save.

5. Reboot the Instant AP.

In the CLI

To configure EthernetEthernet is a network protocol for data transmission over LAN. bridging:

(Instant AP)# enet0-bridging

 

Make the necessary changes to the wired-profile when eth0 is used as the downlink port. For more information, see Configuring a Wired Profile.

/*]]>*/