Device Pre-provisioning

The devices provisioned in your account are listed in the Organization > Network Structure > Device Preprovisioning pane.

To view the Device Preprovisioning page, complete the following steps:

  1. In the WebUI, set the filter to Global.
  2. Under Maintain, click Organization.

    By default, the Network Structure tab is displayed.

  3. Click the Device Preprovisioning tile.

    The Device List table lists the total number of devices; and the number of access points, switches, and gateways in the inventory.

    In the Serial Number column, you must enter the device serial number in full for filtering the data. Entering a partial serial number does not show any search results in the table.

    Figure 1  Device Pre-provisioning

    The following table describes the columns in the Device List table.

    Table 1: Device Details

    Parameter

    Description

    Serial Number

    Serial number of the device.

    MAC Address

    MAC Media Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address of the device.

    Device Type

    Type of device. For example Instant AP, switch, or gateway.

    Model

    Hardware model of the device.

    Part Number

    Part number of the device.

    IP Address

    IP address of the device.

    Name

    Name of the device.

    Group

    Group assigned to the device.

Assigning Factory Default Devices to Groups

To assign factory default devices to a group, complete the following steps in the Device Preprovisioning page:

The following procedure is only for assigning groups to the devices that are not connected. The group management actions like moving devices between groups, or moving devices from unprovisioned group to other groups is done on the Groups page. For more information, see Managing Groups.

  1. In the WebUI, set the filter to Global.
  2. Under Maintain, click Organization.

    By default, the Network Structure tab is displayed.

  3. Click the Device Preprovisioning tile.

    The Device List table is displayed.

  4. Select the device(s) which you want to move to a selected group. You can select and move up to 50 devices at a time.

    If the selected device is already connected to HPE Aruba Networking Central, the Move devices option will not be available for the device.

  5. Click the Move devices icon.

    The Assign Group page is displayed.

  6. Select the Destination Group from the drop-down list.

    You can assign only particular device type for which the group is created. For example, if a group is created for Access Points only, then only Access Points can be assigned to that group. You cannot assign other device types to it.

  7. Click Move.

    The selected device(s) are moved to the destination group. These devices will adopt the destination group configuration.

    For every device pre-provisioning operation, a warning pop-up is displayed to check the audit trail log for the status. If you are assigning the devices in bulk, ensure to check the audit trail to confirm if the all devices are successfully assigned and reason for the rejected devices.

The following animation shows you how to assign the factory default devices to groups in the Device Preprovisioning page.