Configuration > Networking > Routing > Inter-segment DNAT Exceptions
Use this tab to configure inter-segment routing and DNAT rules when traffic is crossing between segments. Click the edit icon and the Inter-Segment Routing & DNAT window opens. Click +Add and select any rule in the table to modify or define the following:
|Appliance Name||Name of the appliance that the DNAT exception is being applied to.|
|Source Segment||Name of the segment traffic is initiating from.|
|Matches Destination IP||IP address that matches the destination segment IP address, before DNAT. The IP address is included in the defined policy match criteria.|
|Send to Segment||Name of the segment the packets are translated to from the matched destination IP address. This is included in the set criteria.|
|Translated Destination||IP address of the DNAT IP address when the segment is translated.|
NOTE: If DNAT is not needed, this field is empty.
|Enabled||Whether inter-segment DNAT is enabled or disabled within your segment.|
|Comment||Any additional information.|
NOTE: This tab only pushes the inter-segment DNAT exceptions to one appliance, selected in the left toolbar.